Your question: Why won’t my Husqvarna push mower start?

A Husqvarna lawn mower may not start because you have a restriction in the fuel supply, a lack of sufficient air flow or a problem in the electrical system. An air filter, dirty carburetor, bad safety switch and faulty gas cap can all cause your Husqvarna’s starting problem.

What can cause a push mower to not start?

Your Mower Won’t Start:

  • Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten.
  • Dirty Air Filter: Clean or replace.
  • Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn’t work, you might need a new fuel filter.

How do I know if my lawn mower spark plug is bad?

Here’s How to Know if a Lawn Mower Spark Plug is Bad

  1. You can’t get the engine to fire up at all.
  2. You have to tug extra hard for longer than usual on the rewind.
  3. Your lawn mower loses power while moving.
  4. The gas runs out quicker than it used to.

What does it mean when your lawn mower starts then stops?

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. … This stops the flow of fuel to the carburetor causing the engine to stall. To determine if the fuel cap vent is clogged, try slightly loosening the cap and then starting the engine.

IT IS IMPORTANT:  You asked: Are reel mowers good for hills?

Where is choke on Husqvarna mower?

You can repair the choke problem by opening the Husqvarna mower’s engine hood and locating the carburetor halfway up the left side of the Husqvarna mower’s Briggs & Stratton engine. The circular choke piece is connected to the carburetor via a metal linkage rod.

Why is it so hard to start my lawn mower?

The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving old fuel in the lawn mower. … This sticky fuel can clog up the fuel filter and make the engine hard to start. If old fuel was left in the lawn mower, drain the old fuel from the fuel tank and replace the fuel filter.

How many pulls should it take to start a lawn mower?

A lawn mower should take between three to four pulls to start. Push the mower a few times to get the wheels turning, then pull the handle quick and far back. Pulling it at the proper distance and speed is crucial for getting it to start as soon as possible.

How often should you replace a lawn mower spark plug?

For standard lawn mower and small engine maintenance, you should check and/or replace spark plugs: once a season. every 25 hours of use. if your lawn mower our outdoor power equipment won’t start.

What kind of spark plug does a push mower take?

Flathead Engine Spark Plugs & Gaps

Replacement Part Type Replacement Spark Plug Options by Briggs & Stratton Part Number Spark Plug Gap
Standard Resistor 796112S 802592S 5095 .030”
Electromagnetic Suppression (EMS) 697451 .030”
Extended Life Series® L-Head Spark Plug Platinum 796560 5062 (5062D, 5062H) .030”
IT IS IMPORTANT:  How much does a 100 hp tractor weight?