Quick Answer: How do you start a craftsman zero turn mower?

How do you start a Craftsman riding lawn mower?

Starting

  1. Step 1: Place the key in the ignition switch.
  2. Step 2: Disengage the PTO by setting the lever to the PTO OFF position.
  3. Step 3: Set the parking brake.
  4. Step 4: Activate the choke.
  5. Step 5: Turn the key to START. …
  6. Step 6: Set the throttle/choke control to FAST before you start mowing.

How do you prime a Craftsman lawn mower?

The gas and air mixture helps make starting a cold mower an easier task.

  1. Look for a flexible push-button style bulb on the carburetor of your Craftsman mower. …
  2. Park the mower on flat, level ground.
  3. Press the primer bulb fully 3 times. …
  4. Crank the engine.

How do you keep a zero turn straight?

Pushing both of the control levers will move your zero turn mower in a straight line. Pushing one control lever farther forward than the other will cause you to turn in the opposite direction. So pushing the right control lever farther forward than the left will cause you to turn to the left.

IT IS IMPORTANT:  How did John Deere get started?

How long does it take to learn to drive a zero turn mower?

Spend as little as 30 minutes in an open grass area to learn how a zero turn mower functions and you’ll be a pro.

Where is the choke on a Craftsman riding lawn mower?

It is a Craftsman riding lawn mower model DLT3000.

The actual choke is located in the opening of the carburetor. It is a plate that restricts the air flow into the carburetor when the throttle lever is placed in the choke/start position.

How do you start a choke on a riding lawn mower?

Pull the Throttle onto Choke Position

Move its lever in order to engage the choke. In most riding lawn mowers, this is done by pulling the throttle lever upwards past fast-a point normally labeled with a circle with diagonal lines through it. Also, you can set the lever between the slow and fast settings.

What would cause a riding mower not to start?

There are many reasons a riding lawn mower won’t start—everything from stale gas to ignition switch problems. If you constantly have to charge the battery, a bad battery or failed alternator could be causing the problem. … Lawn mower ignition switch problems can prevent the starter from getting current.

Why does my Craftsman mower won’t start?

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. … This sticky fuel can clog up the carburetor and prevent the engine from starting. If the carburetor is clogged, try cleaning it with carburetor cleaner.

IT IS IMPORTANT:  You asked: Why does my lawn mower shut off when I engage the blades?

Where is the primer on a Craftsman mower?

The primer bulb on your Craftsman lawn mower engine is attached to the carburetor. This small bulb, when pressed, forces a small amount of fuel into the carburetor.

Where is the primer button on a lawn mower?

Locate the primer bulb on the side of the lawnmower engine. The primer bulb is usually red and located under the carburetor.