Question: Where is choke on Husqvarna push mower?

Where is the choke on a Husqvarna lawn mower?

You can repair the choke problem by opening the Husqvarna mower’s engine hood and locating the carburetor halfway up the left side of the Husqvarna mower’s Briggs & Stratton engine. The circular choke piece is connected to the carburetor via a metal linkage rod.

Where is the choke on a push mower?

There’s a variety of lawn mowers, but for an internal combustion engine, the choke valve is usually located on the body of the engine or a lever on the handle. Most choke valves are butterfly valves mounted in the manifold up from the carburetor jet.

Where does a lawn mower choke start?

A typical starting procedure for an engine with a choke might be:

  1. Close the choke (usually on carburetor).
  2. Set the throttle control (if any) to the START or HIGH position.
  3. Pull the starter cord once or twice (if it doesn’t start on the first one).
  4. If it still doesn’t start, open the choke half way.

Why won’t my Husqvarna push mower start?

A Husqvarna lawn mower may not start because you have a restriction in the fuel supply, a lack of sufficient air flow or a problem in the electrical system. An air filter, dirty carburetor, bad safety switch and faulty gas cap can all cause your Husqvarna’s starting problem.

IT IS IMPORTANT:  How do I know if my tractor tire has a tube?

Why is my lawn mower turning over but not starting?

The most common reason for a riding mower cranking over but not starting is bad gas, but other possible reasons include: Gas Valve Off. No Gas. Choke Fault.

Is choke open or closed when starting?

The choke is only used when starting a cold engine. When doing a cold start, the choke should be closed to limit the amount of air going in. Once the car has warmed up, if the choke does not open fully, the restriction in air may result in reduced power.