How does a lawn mower carburetor choke work?

By restricting the flow of air into the throat of the carburetor, the choke valve reduces the pressure inside the throat, which causes a proportionally greater amount of fuel to be pushed from the main jet into the combustion chamber during cold-running operation.

How does a choke work on a carburetor?

The choke is a plate or blade that covers the primary barrels. It restricts airflow through the carburetor. This means that there is more fuel and less air entering the intake manifold. As the engine warms up, it is able to run on a leaner mixture.

How does auto choke work on lawn mower?

The intelligent Auto Choke System automatically sets the choke to give optimum starting and running in all cutting conditions. The choke valve is automatically opened / closed by operation of the thermo wax assy installed on the intake manifold.

How do I start my lawn mower with a choke?

Open the choke all the way if you notice that it has been closed. If it has been open, the carburetor may be flooded. Close the choke, and pull the starting cord a few times. When you get the engine to sputter, open the choke, and try starting the mower.

IT IS IMPORTANT:  What do you mean by harvesting Class 8?

Is choke on closed or open?

The choke is only used when starting a cold engine. When doing a cold start, the choke should be closed to limit the amount of air going in. Once the car has warmed up, if the choke does not open fully, the restriction in air may result in reduced power.

How do you tell if choke is on or off?

The “choke” is off when the choke lever is down or when the choke lever is facing you if your choke is a handle bar mount. Choke off means that the choke plate is not covering the carb throat.

Why is my lawn mower turning over but not starting?

The most common reason for a riding mower cranking over but not starting is bad gas, but other possible reasons include: Gas Valve Off. No Gas. Choke Fault.

Why does my lawn mower only run with the choke on?

If your lawn mower only runs with the choke on, check the carburetor. … The carburetor brings air and fuel together and mixes them in the perfect ratio for combustion before they enter the engine. There are several passages in the carburetor that allow fuel to enter the air stream depending how the throttle is set.

How do you adjust an air vane governor?

To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open. Then you would turn the bottom “clip” (which is connected to the governor shaft) counter clockwise. This will set the governor shaft on top of the governor spool.

IT IS IMPORTANT:  How do you fix a hard start lawn mower?

How does a choke cable work?

A choke valve/cable is designed to restrict the flow of air in the carburettor of an engine. This helps enrich the fuel-air mixture, improving the ability to start an engine in low temperature conditions. … Simply put, the choke is about making more fuel available for the engine to use.