Frequent question: How do you fix a lawn tractor that won’t start?

Why does my riding mower turn over but not start?

The most common reason for a riding mower cranking over but not starting is bad gas, but other possible reasons include: Gas Valve Off. No Gas. Choke Fault.

How do I diagnose my riding lawn mower that won’t start?

Your Mower Won’t Start:

  1. Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten.
  2. Dirty Air Filter: Clean or replace.
  3. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn’t work, you might need a new fuel filter.

Can a dirty air filter cause a lawn mower not to start?

Your lawn mower’s air filter guards the carburetor and engine from debris like grass clippings and dirt. When the air filter becomes clogged or too dirty, it can prevent the engine from starting.

IT IS IMPORTANT:  What are the two types of harvesting?

How do you force start a lawn mower?

To attempt to force a lawn mower to start, you can try using engine starting fluid spray and spraying it into the air filter. Once the starting fluid is sprayed into the air filter, attempt to start the mower. If it starts up and stays running, then your mower is working and you are good to go.

How do you start a choke on a riding lawn mower?

How to Start a Riding Lawn Mower?

  1. Sit firmly on the seat.
  2. Start the Engine.
  3. Press the Brakes.
  4. Engage the Parking Brake.
  5. Put the Gear to Neutral.
  6. Pull the Throttle onto Choke Position.
  7. Insert the Ignition Key.
  8. Turn the Key to the Right hand side/Clockwise.

How do I know if my starter is bad on my riding mower?

A bad starter can manifest itself in a cranking noise without engine turnover, a clicking when the ignition button is pressed, or a mower that simply does not respond to attempts to start. An indication of a bad starter motor is the absence of other electrical problems that can be more easily tested.

How do you know if the ignition switch is bad on a riding lawn mower?

To check your ignition switch, you can use an ohmmeter to see if there is any connection between the “S” and “B” terminals. If there isn’t any, the ignition switch is your problem and you will need to replace it to get your mower running properly again.

How do I know if I need a new spark plug for my lawn mower?

Any damage to the spark plug requires its replacement. If the spark plug is in good shape but is black with carbon or wet with gasoline, then a good cleaning with a wire brush and adjusting the gap between the electrodes may be all that’s needed for the spark plug to restore power to the mower.

IT IS IMPORTANT:  Quick Answer: What is the meaning of water harvesting?

What does it mean when your lawn mower starts then stops?

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. … This stops the flow of fuel to the carburetor causing the engine to stall. To determine if the fuel cap vent is clogged, try slightly loosening the cap and then starting the engine.

How do you start a lawn mower when its cold?

How to Start a Cold Lawn Mower

  1. Brush the tip of the spark plug with the wire brush to remove any carbon and oil debris. Spray the tip with starter fluid. …
  2. Press the primer button near the air filter cover three times with you thumb. Take your thumb off and allow the primer button to raise back out. …
  3. Start your lawn mower.